Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyoneCould someone please help with the following query.We are trying to implement a change on our network (please see the attached network diagram).Please note that the links in red are new links that needs to be implemented. The 2 sites ar...
Hi everybodyI have 2 problems and appreciate any help resolving them as I am starting to pull my hair out and pretty soon there will none left.- I have a cisco unified network (ACS 5.1, Cisco controller, LWAP) and have configured ACS to integrate wit...
HiI wonder if someone could help me with the following querry.We have deployed a Cisco Unified wireless network for accessing the LAN (we use manyy VLANs). This uses a Cisco 5500 series wireless controller and several LWAP connected to different Cisc...
Hello Gurus,This is my question:I have created a Vlan 20 on a cisco switch. This VLAN will be used for devices that will have IP addresses in the range say 192.168.10.0/24 and I want these devices to communicate amongst each other BUT1. they cannot c...
HelloI am having a go at configuring ACL. The requirements are:- I use a layer 3 switch for routing- I have 4 Vlans on my network, Vlan1, Vlan2, Vlan3 and Vlan4- Devices on Vlan4 should not be accessed by any device outside Vlan4, except for one devi...
Hi ScottThat is precisely what I have been trying to do but for the life of me I cannot find where to access this on ACS.This is the type of log I am after
HiMany thanks for your help so far. Below are the rules used. The service selection rule The authorization rules for the "Wireless Access" access serviceInitially I was using authorization rules 1 and 2 then I disabled them and now that I am using on...
Thanks Toshi for your reply. I knew that I needed to implement a routing protocol between 2 sites but I need help on where and how to implement.ThanksRaoul
It is just wireless. I don't want to set the default rule to deny otherwise users will not be able to access the network. The autorization rule should get matched but can't put my finger as to why it doesn't.
