Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Got a SR2024CT-NA SG 102-24 smb switch with fibre sfp running to an old 3com switch. It is supposed to actually replace a 3com on the source side. There is connectivity but they say its very poor and clients from the 3 com end on the other end c...
Hi,i have a 5510 and the asdm was working fine all the time. But the there was a power outage and ups ran out etc. On boot, internet works but asdm cannot be accessed and also remote access vpn does not work anymore. When i cli to it , i see all the ...
HiI have been trying to trunk to 2960 switches and can't seem to get a proper connection. I am using packet tacer. The 1st switch already has a trunk port going to a router and the router has port is trunked and has sub ints for each of vlans 2 an...
Hi,i got 2 3500 series XL switches for labing. I already know that I can't use int range for configs because of the old IOS 12-0-5.WC17, its actually the highest one that can run on it, memory limitations for higher IOS i gather.Anyway, is there a wa...
Hi,I do beleive that the recommended NetFlow software requirements for the 4510R sup V is IOS 12.2(25)SG or later. Each sup will also need the NetFlow cards for stateful switch over.
Hi Dasuntha ,Thanks for link. As I installed 5.3 and opened up the tracer file from 5.2, the network converged in 2 secs and worked perfectly like it should. Thanks for letting me know it worked all the time and my sanity was good. I had decided to ...
I believe it may be a bug yes. I have 5.2.3 PT. Also crashes when overloaded and trying to converge. If my config works on physical devices with similar setup, then logically it should be app problem. Can either of you send me 5.3 plz to my email ad...
Hi Dinesh,What version packet tracer you compiled. Your file cannot open with packet tracer 4.1 and packet tracer 5.2Also you say your using my config and it works. If so then it sounds buggy to me. Confirm and resend please, I would like to view tho...
Hi,I tried what you said m8, but only brings up one side green. Links are indeed up but as I said no ping traffic passes. I recon this is a bug in packrt logic. I have tested this same setup on physical switches and works like it should with switchpo...
