Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All, Currently trying to build a simple solution allowing us to maintain control over browse behaviour without user agents or whatever. CWS can do that for us since we use ISR G2's and we could just push the traffic to the service cloud on gateway le...
Hi All,We're experiencing some strange interface behavior on two 3G connection on the same 1841 router. The cellular interfaces go into reset exactly two minutes after it came and this repeats continously. See below output when we ...
My fellow engineers,Having a strange issue here with an 7606-s chassis equipped with two sup720's, and two regular line cards. There is only one power supply, PWR-2700-AC. I recently builded this setup and powered it on last week for the first time. ...
Hi Edan, Sounds good. Yes, I've defined separate IP blocks for Guest and non-Guest users.You might have any link with some sample config for a warn rule. I'll request a trial and build a lab to play around. Thanks.
You say under the interface it does not take the command. I could not see in your explanation where you did this but your physical interfaces are set to be access ports so you need to do this under the vlan interface the ports are set to.
did you specify a dialer-list to define interesting traffic? Without that the router will not know when to bring up the interface add this under global config: dialer-list 1 protocol ip permitand a static route using the interface: ip route 0.0.0.0 0...
