Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I work in an environment where it is QoS-centric. I was reading up on the "Off Channel Scanning Defer" setting on the Advanced tab of the WLANs configuration. By default, the Scan Defer Priority is set for 4,5,6 and the Scan Defer time is set to 10...
Hello, We are interested in disabling the 802.11b data rates on one of our 5508 WLCs. However, we do not want to do this globally as we do have some WAPs in an area that still support 802.11b clients. so, we want to advertise 802.11b rates only on ...
I have a customer that would like a 40Gb port-channel between two 3750-x switch stacks. When I try to activate four 10Gb ports in the channel, they go into error-disable. However, I am able to create a 20Gb port-channel without issue. I have had m...
Hello,I recieve the same critical alerts in WCS the same time each week on the same 2100 series WLC:Port '3' is down on Controller '10.x.x.x. - Controller Name: WLC1Port '4' is down on Controller '10.x.x.x. - Controller Name: WLC1Port '5' is down on ...
We were told by TAC that the CSR procedures for Prime Infrastructure must be followed exactly for the import to be successful, therefore it is not possible to add a Subject Alternative Name to the certificate.
We will be adding this to our feature r...
Hello,
We are running Prime 3.1 and would like to add a "Subject Alternative Name" to the CSR. There are no documented steps on how to do this. Do you have any suggestions on how to accomplish this task? We are able to generate a CSR with SAN usi...
"RF Groups are groups of controllers that share the same RF group name and who’s APs can hear the neighbor messages of each other. "I have a similar situation where my controllers are supporting APs that are deployed in different locations throughout...
Can this be done with a route pattern say if we prefix a pattern with 001023 but the telco rejects the call, we want to re-route the call with a prefix of 0 and then traverse the same outbound circuit. Is this possible?
