Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
have a 9500-24q which only supports 40G connections. Need to provide some minimal 10G (SR) connectivity. How can this be done? looking to use standard mm om-3 type cables between the devices.
Searching in vein
thanks
Sorry if this has been posted twice.Trying to do a packet capture with nat'ed addresses (twice nat). Don't know what IP's I should have in the capture ACL. Could experiment but would also like to understand going forward. here are the objects and n...
Rather than opening a case would like to understand how OSPF works on a lan when we have HSRP active.To describe the issue I have three l3 switches tied A - B - C all running ospf and on the same vlan. HSRP runs between B and C with C being both the...
Our network suffered a significant event today and have been wondering about root cause. Shouldn't the layer 3 side just drop bpdu packets and not forward any.
thanksCisco needs better documentation on this as would never have known about not seeing traffic on the outside "encrypted" interface unless you mentioned. Did a lot of web searching as well.
would like to review the report and rather than seeing a link like the instructions say I get this
<a title="SourceFire Cisco IPS" href="/sourcefire-snort-ips-ids" target="_blank"><strong>Cisco SourceFire</strong></a>
sample configurationone endint gig 1/1no switchportno ip addresson the other endint gig 1/1switchport mode accessswitchport access vlan 5spanning-tree portfastshould this be transparent/non-functional or should it cause network issues
Interested in building a test callmanager system for my home lab.Any details on the registry modifications I would need to make to get Callmanager to load.Again, this is strictly for a home lab.thanks
