Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know how I can see what the internal temperature of a WLC-2006. My WLC 2006 is running software version 4.2.130.0. Thanks,ETWith my 4400 and 2100 serie WLCs I can verify the internal temperature by either the web browser's monitor tab or ...
I was wondering if the ISR Routers (Cisco 1811w) support the root-bridge and non-root-bridge feature. If not is there another device apart from the 1310 and 1410 bridges that support this feature?Thank You,VT
We currently have an 831 and 1800 series router each connected to a different ISP using ADSL. The two routers belong to the same HSRP group and only one acts as the internet gateway while the other one is on standby. We would like to Track the Virtua...
As per Cisco IOS design when authentication fails the switch sends a simulated EAP-Success message to the client so that DHCP can be implemented by the client. Taking into consideration the dot1x auth-fail command is configured.However we have notice...
I am trying to interconnect a Catalyst 3750 and a 2948G-L3 using fiber GBIC. The interfaces where the GBIC and fiber are attached show up as physically down. I have tried different ports and also changed both switches. No Luck. If I connect a 3524 t...
How was the stacked hub connected? If redundant connections were used between Hub1 and Hub2 then that can cause a storm. Also, if the the second hub had a connection to a switchport, then that too can cause a loop.A hub like a switch will forward a ...
Stackpower gives you the option to share the Power Supplies between all stack memebrs (Max 4).There are two configuration modes for StackPower, Redundant Mode and Shared Mode.In redundant mode, as t relates to your situation, one PS will be in standb...
Not sure if your issue is resolved, but here is a quick example....Lets say that ISP A advertises prefix 31.31.31.0/24 to the customer router you can configure HSRP in the following waytrack 30 ip route 31.31.31.0 255.255.255.0 reachabilityinterface...
Does the ISP advertise any routes to the customer routers? If so you can configure tracking of these routes. So basically if there is an outage in the providers network these routes should no longer appear in the customer RIB. With tracking of routes...
Steen,What is the Default Gateway that DHCP is providing to the remote clients? Can you provide a traceroute from the remote client towards 10.45.16.0/24.
