Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi,we have one XDM 1000 and one GSR 12000 at one placeand in noc we have one xdm 100 and and one Edge 7206 VXR.now we want to aggregate or increase the backend connectivity between EDGE and GSR.can it possible the STM 4 or STM 16 bandwidth between th...
Hi,We are having Fully deployed MPLS based IP networkIn our NoC we are having one Edge PE router from that one L3 3550 switch is connected.In that L3 switch fa 0/1 connected to a separate switch to customers.in that we are connected 15 customers all ...
I want to Monitor Vlan trafficsome of our equipment is not supported SNMP.so all our customer gateway is defined in NoC L3 swithas a differnt VLANwhen ever we try to take MRTG from L3 it shows vlan traffic is 100bits/sec but this customer is geetiing...
We have connected some customer through leaseline through router serial interface .the main problem is sometime the leaseckt is down for 2 or 3 days continously.so we want redundancy for those customer.we have backup rf linkso any possiblities are th...
Hi in this figure the customer have one ip 16 ip block that is oruted with IGRP in PE routerwe want either link customer use same ip block.and in RF link Base Station is connected in L3 Swith Fast Eternet port.All rf customers are in different VLANS....
thanks for your info.i tried but i dont have enough privilege level to craete policy in switchso without policy how can i implement CAR in interface.and i need a one more info if more than one customer connected on that interface ech having separate ...
