cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
781
Views
0
Helpful
5
Replies

Bandwidth restriction on FastEthernet interface

tvm_parthiban83
Level 1
Level 1

5 Replies 5

spremkumar
Level 9
Level 9

hi

You can make use of CAR (Rate-limit) commands to restrict the bandwidth as per the requirement.

Also you can make use of Class based policing to achieve the same.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800c75ce.html

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00804a27c4.html

regds

thanks for your info.

i tried but i dont have enough privilege level to craete policy in switch

so without policy how can i implement CAR in interface.

and i need a one more info if more than one customer connected on that interface ech having separate vlan id.

so can i implement this car in vlan interface?

hi

I did give the CAR suggestion thinking off that you are trying with your router.

Pls post out the switch model and info on how the customers are getting connected to the switches..

regds

hi

I did give the CAR suggestion thinking off that you are trying with your router.

Pls post out the switch model and info on how the customers are getting connected to the switches..

regds

hi

I did give the CAR suggestion thinking off that you are trying with your router.

Pls post out the switch model and info on how the customers are getting connected to the switches..

regds