Hi everybodyI have an question on QOS. Interserv uses TOS IP Precedence field to classify the traffic while Diffserv uses DSCP to classify the traffic as diffserv dont have IP Precedence field as TOS is rewritten. But in some cisco books and on cisoc...
Hi,Is it possible to use both the 10GE ports on both Active and Standby Supervisor Engine V-10GE simultaneously as Routed L3 ports on a 4507R. Also let know on which IOS version this is possible.ThanksDeepinder
I c that ur VLAN 1 is in passsive mode, remove it from passive mode. I hope all the neighbors will form adjacancy after that.If this info was helpfull please rate that.Thanks & RegardsDeepinder Singh Babbar
Hi Jorge,I think there is a configuration problem with 6500. Either there is a interface in passive mode or there is an access list blocking EIGRP hello packets.It would be better if u could send config of 6500 and tell us on which ports r these 3 eq...
Hi Balajee,Type 3 LSA (Network Summary)are generated by the Area Border router (ABR) and sent into a single area to advertise destinations outside that area but within OSPF domain.Type 4 LSA (ASBR Summary) are also generated by ABR but advertise addr...
Check the below mentioned link that will help u in configuring MGMT Port in case of disaster.http://www.cisco.com/en/US/products/hw/switches/ps663/products_configuration_example09186a0080094ecf.shtml#imagePlease Rate if info was helpful.ThanksDeepind...
