Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have a stack of 2 3750G with enhanced software running as my OSPF routers to our duel WAN lines (both used simultaneously, both same size)Since yesterday I have changed 2 parts of the configthe SDM is now the Routing Dual IP V4 & 6and system...
Hi All,the title says it all really, I have added a MIB already to my PRTG monitor but the number of channels that it gave me does not much up at any time at all with what I see on my 3925 router.Please help.ThanksFraser
Hi All.I have read this many many times that the ASA's still do not support DynDNS. Does anyone have any ideas on when this will happen ? This is probably stopping many users from upgrading to a proper firewall instaed of using a "DSL" router to do t...
Hi AllI would like to know the actual power requirement for a 8961 when used with a 3750x SwitchI have seen only 15.4 W in every document I have found but that just goes by the fact that the phones are class 3.A 7962 is class 2 but uses only 6.2W ins...
Hi AllI am trying to get 5 "BOUGHT AS NEW" 1141 LWAP's connected to our WLC5508But it looks like they already have been connected to a WLC. and when I try to type in the few needed commands I get "ERROR!!!! Command Disabled" back.I have read somewher...
Hey NikMy main problem was with the newly added switch not being able to join the stack unless it had a direct connection to the master Switch - and that is why i have to take option 2.The top switch is always master in my stacks (to begin with) and ...
Hi All, I always have a problem when stacking the 3750x (building a new stack).Every new switch that gets added to the stack has to have a Direct Connection to the stack master to be able to join the stack without starting up as a standalone...
check this out too guys.....from CDP on a 3750X Switch for a 8961 IP Phone......Device ID: SEPE840400CF086Entry address(es): IP address: 10.146.160.26Platform: Cisco IP Phone 8961, Capabilities: Host Phone Two-port Mac RelayInterface: GigabitEthern...
Thanks Mark and CiscoIsInYou for both your answers.I Need IPV6 for a few Server2008R2 Features.But I had to change back to the standard IPV4 Routing SDM yesterday as the Software routing was making the RTD go from 3ms to 150 ms on specific subnets - ...
