About eshah

eshah · 03-10-2006

Presently we have in our possession a Cisco AS 2509-RJ router which is presently used for remote Access, so that employess can Dial-in , and gain access to the company network. We would now like this router to provide call-back so that the cost of th...

eshah · 03-08-2006

Presently we have a cisco 2501 router connected to an external lease line for providing internet access on the serial port of the router. The Router is also connected to a Firewall Server via the ethernet port on the Router. Presently the we are unab...

eshah · 09-29-2005

We have some Cisco 1750 routers at the edge of our network which are running RIP. We were advised to use static routes on the router, since there was only one route (across a WAN link) for traffic to go from the hub connected to the router, as RIP wo...

eshah · 04-28-2005

We have some Cisco 1750 routers at the edge of our network which are running RIP. We were advised to use static routes on the router, since there was only one route (across a WAN link) for traffic to go from the hub connected to the router, as RIP wo...

eshah · 03-09-2006

I got the telnet to work properly, I mistakenly provided you with some erroneous information, but the help you gave earlier was key to me solving the problem. It works perfectly fine now, thanks

eshah · 03-09-2006

I tried the commands listed and I was still unable to telnet into the router. I go the following error message " Connecting to 209.94.197.97.... Could not open a connection to host on port 23: Connect failed "Could you provide some further guidance p...

eshah · 09-29-2005

Here is the configuration, hope it helps ?

eshah · 09-29-2005

The work Salvage refers to a location, at this location (building) we have a 1750series router.This router is the remote edger router.The 1750 series router at Salvage is connected via its serial port (172.20.2.2) to a Cisco 3640 router (172.20.1.4)...

eshah · 09-29-2005

Yes , I can post the configuration and i will do so as soon as possible, I made one mistake we are able to connect to the router via the serial port , but not the ethernet port.

Member Since	‎04-28-2005 03:22 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	9

User Statistics

User Activity

Setting up callback - Cisco AS 2509-RJ

Cisco 2501 Telnet Restricting and Allowing

Configuring static routes at the network edge

Configuring static routes at the network edge

Re: Cisco 2501 Telnet Restricting and Allowing

Re: Cisco 2501 Telnet Restricting and Allowing

Re: Configuring static routes at the network edge

Re: Configuring static routes at the network edge

Re: Configuring static routes at the network edge