About cISCOJester

cISCOJester · 01-08-2008

I have been running into walls trying to determine the correct router for one of my remote locations. I have some set requirements and some not so set. First it must have the DynamicVPN support to handle spoke to spoke communication. Must have an ...

cISCOJester · 10-25-2006

Not sure if this is the correct fourm, but i will try it. I am trying to direct ssh traffic to a specific server on my network through my 2811 router. When a remote client attempts to initiate a session with the server the get the login for the rou...

cISCOJester · 08-31-2006

I am attempting to set up a VPN connection from a 2801 Cisco router across my 2811 Cisco router to a non Cisco Sonicwall router. The LAN with the 2801 router is a stub network with a Point to Point to the 2811 with its only access out. I believe th...

cISCOJester · 08-07-2006

In a general question, is it possible to have a remote LAN connected by a Point-to-Point where only half or some of the LAN's IP addresses are translated and the others are sent without translation?This question arises from the need to have my IP pho...

cISCOJester · 06-06-2006

I have a 2811 with a VWIC for support of data and voice transmission across the point to point T1 WAN to my Nortel BCM phone service (the other end is a 1801 with VWIC). My question is: i am having trouble finding the appropriate CLI commands for pr...

cISCOJester · 01-10-2008

Thank you Brandon.I was thinking that this was the way to go as i have two of the 2800 series in other location already. Was hoping to get something less expensive. Thank you for confirming my take on the situation. Jester

cISCOJester · 10-26-2006

Yes i do need SSH service from the internet to my server and across the VPNs to my server. I do not believe i am NATing the VPN connections to the server. The NATing for the endpoints of the VPN tunnels are strictly for internet access out of the r...

cISCOJester · 10-26-2006

Thank you frank!Yes i have modified the ACLs for the telnet session, and last night was able to get a NATed ssh session through to the server with the new command.My new issue is this:I have three VPNs coming in to the main location where the server ...

cISCOJester · 09-01-2006

Thank you for the info,Below is my Sonicwall information its a few years old:As for my IOS i dont have exact versions at my fingers right now but i can say that both routers are running 12.4(T8) or newer.My network setup is in a transition phase as ...

cISCOJester · 08-08-2006

Thank you Wilson,Would PIX Firewall box be necessary on a stub network. The remote router has one connection out the Point to Point line to my main "hub" router. I was planning to use the security features in the software build i have and had not t...

Member Since	‎05-13-2005 12:31 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	16

User Statistics

User Activity

Trying to find the correct router

SSH services

"Spoke" VPN to "Spoke" VPN

NAT over WAN

2811 with VWICs

Re: Trying to find the correct router

Re: SSH services

Re: SSH services

Re: "Spoke" VPN to "Spoke" VPN

Re: NAT over WAN