Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Platform: Cisco 1760 running 12.4(8) ipvoice with VIC4fxo module in slot 2.Problem: When in SRST mode outbound calls work fine. The dial-peers steer all pstn calls out the fxo ports. However, when calling in on one of the pots lines connected to the ...
I recently converted a 1231G from 12.3(7)JA IOS to LWAPP 12.3(7)JX. The AP now tries to join the controller (4404)but receives no join response and reboots. I have heard a rumor that there may be a problem with the certificate that's created on the A...
During the Unity application installation there are 3 users created automatically on the Domino server, EAdmin, USbms_servername, Unity_servername. When I run the DUT.EXE utility (d:\commserver\utilities\domino\dut\dut.exe) on the Unity server (ver. ...
When users doubleclick on a VM in their Notes client, they get a message saying "Cannot locate form: fa_RcvdVoiceMail." When they X out of the error they then get their VM and can listen to it ok. Unity ver 4.05Notes ver 6.5.1Is there a plugin they n...
Could someone point me to any information on the correct procedure to replace a SATA hard drive that is in a raid 1 (mirrored) configuration? I am going to be replacing a fully functional drive in the secondary bay in an MCS-7825-IPC1 server. Do I ne...
12.3(11)T10 did indeed fix the disconnect issue. Thank you for that info. The incoming call issue was due to:I believe I have discovered the cause of this issue. As you mentioned the other day the debugs reveal that the fxo module is trying to contac...
At this point that is the only thing that makes sense. We have inbound calls coming into these same fxo ports all the time while it's operating in MGCP. So it doesn't seem to be a disconnect supervision setting thats wrong. We went from 12.3(8)T3 to ...
12.4(3e) ok, I'll try that. I upgraded from 12.3(8), which TAC said was defferred, to resolve this issue already. The configuration used to work but we found out recently that all sites now have this problem. The only change I know for sure that occu...
