Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to restrict the wireless transmission range? If so, how granular can it be set? For instance, if I want to allow reception only within a 50 to 100 foot radius of the base station (assuming an open field environment). Will lowering t...
Is there a special MIB that will allow SNMP to send information regarding traffic over a specific 802.1Q VLAN? Using a Cat4006, w/SupIII, I am providing GigE services to multiple businesses. The 4006 has one aggregated FE connection to a 7206 router ...
Thanks, I wasn't thinking about a static to null0, which is simple.On a different issue, I've tried to disable arp learning on the access-interface, both at the parent interface and at the dot1q subinterface. Neither stops arp learning by the sessio...
Roy,How are addresses from a pool "address-range" advertised in IGP? Since no address within the range exists on an interface, how would opsf redistribute it? Thanks,Dow
In reference to Cisco Wireless base stations, in what increments does the transmitter adjust? For instance, 1/10 mW, 1/100 mW, 1/1000 mW? Is the transmitter adjusted via software, or is it a physical hardware adjustment?
