Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After successfully adding LDAP on my ASA Firepower, i have tried blocking/allowing a web site to a particular user. Unfortunately the condition is not working. If i use an IP address instead then the site is successfully allowed/blocked. I am using...
Hi, I am trying to allow http/80 connection on my new asa 5516 to access a web server. I am using static nat with port translation to redirect the traffic to the web server. There are 2 problems: 1) Http traffic is blocked as soon as it arrives at...
Hi, Is there a way to change the time on Cisco Firesight Management Center after i have finished with the initial configuration. I need to change the Timezone again as it was set to the wrong value and i cannot find an option to do so. We are runni...
Hi, I am trying to configure port-channel on SG300 L3 switch. When i try to assign an ip to the interface i get the following error: Sw2Fl4(config-if)#ip address 192.168.2.16 255.255.255.0 Duplicated IP interface on the same subnet. The management ip...
It does not matter. I had this issue 2 times and never had to disable failover. When the replacement unit arrives configure the failover Link and connect only that to the network. When the replication is done you can connect the other interfaces and ...
Dear Martin, So the replication of the configuration will happen from secondary unit to primary as well? Taken under consideration that when the secondary unit is active all changes are replicated to primary unit , i presume the same for the failur...
Hi, i know this post is old but what if you have an inside ACL on a lower security level interface to allow traffic to another zone? The default hight to low permission does not work. How can you allow internet access? Do you have to deny fisrt commu...
The issue seemed to be the security settings on java rather the version itself. Mine worked with version 8 Update 171 and the latest ASDM 7.12. The trick with the shortcut did the job as well for the issue "Application not compatible". Thanks
