Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Cisco Community,After upgrading a Cisco c9800 WLC I get the following error message when booting.boot: unsupported boot device "flash"autoboot: boot failed, restarting...and then it boots into the old image.New image: C9800-L-universalk9_wlc.17...
Is there away to find a sticky MAC on a different switch from the router/core? I realize port security does not span switches. I was looking for a way to find a Sticky MAC on a switch from the core that has been been aged out of the MAC address table...
Hello,
I would like to get some opinions on grouping multiple dynamic interfaces (VLans) to a SSID vs using one large subnet. What are the advantages or disadvantages or is it only preference.
I hope I'm wording this correctly.
Hello All,
I searched the forums and only found one other discussion unresolved regarding this.
After upgrading a bunch of Cisco 3560s (some new out of box and some used) I get these errors on boot. On the other discussion someone mentioned it may be...
I've been tasked with deploying AIR-LAP1142N-A-K9 connecting to our WLC5508. Our security officer has asked me what configuration is stored on the actual AP. When I try to console into the AP it prompts me for a username and password. I have not set ...
That is the complete show boot.WLC1#sho bootBOOT variable = flash:packages.conf,12;CONFIG_FILE variable =BOOTLDR variable does not existConfiguration register is 0x102WLC1#
Thanks, here are the outputs #sho bootBOOT variable = flash:packages.conf,12;CONFIG_FILE variable =BOOTLDR variable does not existConfiguration register is 0x102#sho run | inc bootboot-start-markerboot system flash:packages.confboot-end-markerdiagnos...
Hi Rich R,Sorry for the late reply do you know were I can find examples of this configuration. I plan on implementing the same config soon."We have HA-SSO pair in DC1 doing N+1 with HA-SSO pair in DC2 with APs split across the two pairs. So all the ...
