Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi ExpertsI have a very strange experience in which I moved the trunk link from one switch to another and this movement of cable is making SVI down/down.Connectivity like below:Current Connectivity: Switch A<------trunk vlan 100--------->Switch BNew ...
Hi ExpertsI am doing the base build of switches in stack C9200L048T-4x. SW : 17.06.03.I am configuring the basic ssh to build switches and problem is : when i accessing this switch through other switch locally then login response and running the com...
Hi All, I have two Edge routers (Primary and secondary) which are connected with AWS and AZURE cloud provider (eBGP connectivity) and respective VRFs (AWS and AZURE) are created on these routers. Problem: When I am doing inter-VRF route leaking betw...
Hi Experts, I want to know the Clear steps + Exact commands regarding inter VRF communication (for selected subnets only) on Nexus9000 C93180YC-FX.Clear Steps : means I should not miss any steps, so my change should be successful in one Go.Exact comm...
Hi Experts, I want to know if Local preference and AS path prepend will work or not in my Scenario. Scenario : At my customer edge side I have two routers which are in AS 100 and have IBGP, these both Customer edge routers are making the eBGP with di...
Hi ExpertsI have fixed this issue, it is very strange issue and it can help someone. so sharing my experience:In current connectivity Trunk was running perfectly fine between Switch A and Switch B. (Both IOS devices).In new Connectivity there was nee...
Hi ExpertsConnectivity like below:Current Connectivity: Switch A<------trunk vlan 100--------->Switch BNew Connectivity : Switch C<--------Trunk vlan100----------> Switch BSwitch A config: 6509-E, layer 3 SVI created on itint xx/xxswitchportswitchpor...
Hi ExpertsI have been working on this since morning and did some research and fixed it.@MHM: yes it was both during login and command run.Solution I applied: So routing can be the one of the issues to make it slow. there was default route missed towa...
thanks for your reply, but cpu utilization is very normalCPU utilization for five seconds: 1Percent/0Percent; one minute: 1Percent; five minutes: 1 Percent
