Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We had enabled the Default Network Device on our ACS 5.3 during the setup stage.
Now I wish to implement a policy for specific network devices so I have now added the devices uniquely using their IP Addresses and names.
However the policy is not work...
We have a vulnerability that requires we "disable NTP readvar queries" on a Cisco ASR with IOS v15.1.Not sure how to go about this. The report recommends that we add "restrict default mask 0.0.0.0 noquery" to the file: /etc/ntp.conf.We can't find thi...
Dear All,We use ASDM 6.2 to manage our Cisco ASA 5520 running ASA Software Version 8.2 (1).I just noticed that some static routes have "A-" when you view the static routes with ASDM e.g. A-172.24.0.0 or A-192.168.176.0 (pls see attached print screen)...
Hi All,After a power problem at our data centre we find Module 11 of our Cisco 6513 Core Switch in PWR Down state.Show Module 11 returns: Status: PWRDownShow Power Status Module 11 returns: OperStatus Off (Module Reset due to an exception or user req...
Hi All,I have a NAT Router before a BGP Internet Router set up as follows:LANs 1 and 2 ==> NATRouter ----> BGPRouter ==> ISP 1 and ISP 2On the NAT Router, 2 distinct LANs (10.2.8.0 /24 and 172.16.0.0 /16) come in from 2 different Interfaces but go ou...
Good morning Gagan,
I clicked on the magnifying glass and saw in the detailed log that the IP Address the ACS was seeing was different from the one I had specified for the device.
I changed it and it worked.
Thanks a million for your help and guid...
Yes the rule is not matching because the device is still showing on the ACS as a "Default Network Device".
The rule is set to match if a device is in a particular location.
I have added this device to the ACS with its IP Address and specified its l...
Thanks for your reply Gagan,
I had disabled Default Network Device but the authentication didn't work till I re-enabled the Default Network Device.
I also tried to change the IP Address I used to add the device to the ACS. I used other interfaces' I...
