Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Our CUCM 11.0.1.20000-2 on BE6K-S. Recently we found that phones are not auto registering. While we manually add phones, it is working.
In phones status messages is showing TFTP timeout. I did packet capture in Call Manager.
Requst to CTL and ITL ...
Hi,
I am using WLC 5508 with 8.0.120.0 firmware. We were doing profiling and recently updated OUI list downloading from http://standards.ieee.org/develop/regauth/oui/oui.txt (Ref: http://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/7...
We have purchased new BE6KS. I don't find much document to configure it but found some basic configuration examples. The box came with 3 Interfaces in Router and a module UCS-E160D-M2/K9 .In all examples i found router interfaces are using for commu...
We have purchased new BE6KS. I don't find much document to configure it but found some basic configuration examples. The box came with 3 Interfaces in Router and a module UCS-E160D-M2/K9 .In all examples i found router interfaces are using for commu...
Hi, I have configured SAF in CUCMEs and configured a SAF Forwarder for CUCM. All CUCMEs are learning and advertising DNs and able to call each other. SAF Forwarder registered CUCM as client and in CUCM I can see learned DNs too. CUCMEs are learning C...
Yea, Auto registration enabled. We are using BE6K-S in this site and only a publisher there. Auto registration was working fine and this week only it started to show the trouble.
I found a discussion in this link
https://supportforums.cisco.com/discussion/12476321/wlc-5508-after-updating-ouitxt-device-type-unknown-or-unclassified
