Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am having a Cisco 2851 router with IOS firewall software(c2800nm-advipservicesk9-mz.124-15.T6.bin). I need to have two access-groups (one for in, and one for out) on the same interface. Traffic initiated from this interface (so matched by the "...
Hi guys,I am trying to setup a Trixbox conference. This is working OK but when call from PSTN then the DTMF digits are not recognized. If I call from a SCCP phone which is registered to our callmanager it is working without a problem.This is my setup...
Hi, I have to replace the current DECT system of one of our sites. We already have a callmanager 6.1 available. We also have some Cisco AP 1131AG's at this site. I have two questions about this:1.Do I need a WLC if I want to roam between AP's with a ...
Hi,I am looking for a camera which is having the best specifications for Video advantage. It looks like the Microsoft LifeCam NX-6000 is the one. (1600 x 1190 with 30 fps) Does anyone have experience with this camera or who has good experience with...
Hi, I tested a lot of cameras which are not in this list. They are all working. See post:http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=Video%20over%20IP&CommCmd=MB%3Fcmd%3Dpass_through%2...
Hi Paluchpeter,Apparently I made a typo. (I adjusted the IP addresses, I also mentioned this in the post)The IP address of the inferface should be 1.2.3.1interface GigabitEthernet0/0.12 description ABC_vlan encapsulation dot1Q 12 ip address 1.2.3.1 2...
HI Nick,Thanks for your answer This is the output of this command, it is still not working.rotnar01(config-dial-peer)#rtp payload-type nte 121 ERROR: value 121 in use!rotnar01(config-dial-peer)#rtp payload-type nte 101 rotnar01(config-dial-peer)#Here...
Hi Nick,Thanks a lot for your answer.The H323 protocol is used between the router and Callmanager. A SIP trunk is used between Trixbox and Callmanager. Isn't it something between CUCM and Trixbox then? I am not sure what is used on the Trixbox. I nee...
