Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have an Active/Standby pair of ASA5520 devices connected to the core with a /27 public IP address. We also have an Active/Standby pair of ASA5525-X devices connected to the core with a /28 public IP address. The default route from the core goes ...
I have a Nexus 5548 switch that has HSRP configured on several of its VLAN interfaces. This switch also has a routed interface for a point-to-point link to a remote site. The routed interface is *not* configured for HSRP, however, HSRP hello packet...
Can't get Netflow information to export from my 3850 into Solarwinds. I know that Solarwinds is properly collecting Netflow information as it's currently doing so for a pair of ASAs. Below is my Netflow config:
flow record 9550-to-6111 match ipv4...
We have Cisco Prime Infrastructure 3.0 setup on our network as a NetFlow collector. Currently, the ASA5520 at the network edge is setup to export NetFlow information to CIsco PI 3.0. We're looking to use Prime as a network traffic analyzer to gauge i...
@Philip D'Ath wrote:
I have done this before, but it can be a bit nasty sometimes.
Configure two outside interfaces, outside-att and outside-windstream. Then use policy routing to decide which outside interface to use.
For example, traffic from ...
@Philip D'Ath wrote:
If the address space is from the same ISP - can you not just ask them to route the existing /27 down your /28?
The /27 is from AT&T, the /28 is from Windstream.
@Georg Pauwen wrote:
Hello,
can you post the Wireshark capture ?
This forum won't allow me to attach a .pcap file so I have attached a screenshot of the Wireshark output.
Thanks.
I did a monitor capture on the Catalyst 3850 at the other end of the P2P link capturing all IP traffic coming across the link. I then exported the capture information into Wireshark.
