Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all. I have a DSL bridge connected to the WAN port of a Cisco 831. For whatever reason, the 831 does not negotiate PPPoE. When I connect a simple Linksys router to the bridge, it works fine.debug pppoe events on the 831 shows the following repea...
Hi all.I have a 2wire DSL router configured as a layer 2 bridge and directly connected to it is a Cisco 831.I would like to have the Cisco 831 running as a PPPoE client for the DSL connection and NAT for my LAN. However, I cannot get my configuration...
Hello all, first time using Cisco and I'm faily noobish so please bear with me.I have a 2wire DSL multifunction unit and a Cisco 831 behind the 2wire. I'm having a problem getting the network running properly.As currently configured, from the Cisco ...
Thanks for all the help everyone.After viewing the ppp auth debug I realized that my IP address is not assigned via DHCP but rather it should have been set to ppp negotiated.Problem solved! Thanks again.
Sorry for the delay in testing these suggestions. I've been fairly busy Anyways, I removed the SSH from the vty, just to eliminate that possible issue.I also added ip route 0.0.0.0 0.0.0.0 dialer0.The dialer0 interface never receives an IP address....
Solution Found.Basically, CIDR/VLSM got me where I need to be.I set the 2wire LAN port to 192.168.1.254/16. The outside of the Cisco got 192.168.1.1/16 and the inside got 192.168.200/17.Added a static 0.0.0.0 0.0.0.0 192.168.1.254 to the Cisco and I...
According to ATT's excellent support dept, attaching a Cisco 831 behind a 2wire will damage either or both devices.... right.So, long story short, I was told I could not configure the NAPT options on the 2wire apart from specifying which private rang...
