Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am investigating a migration from the VMware vDS to the Nexus 1000V - is there a recommendation for the how many uplink port-profiles (port-profile type ethernet) there should be?The current VMware vDS has two uplink ports, with one pNIC from ea...
Hi, Summary of problem: - Incoming frames on three of a blade's four switchports are being put into VLAN 1 even though the ports are either in other access VLANs, or are configured as trunks with different VLAN IDs being tagged by the server.- When t...
On a low-end switch like a 2960 the maximum VLANs is 255, as shown in the output of VTP status:Maximum VLANs supported locally : 255Number of existing VLANs : 245When the VTP mode is changed to transparent, VLANs from the extended range ca...
I have set up a remote-access VPN using the ASA VPN wizard. When I test the connection with the Cisco VPN Client I connect successfully and get assigned an IP address from the pool I specified. However I can't send any traffic to the network behind t...
Hi,Yes, the additional high-number VLANs (that aren't being counted towards the 255 limit) do work across trunks - I have trunked them to another switch and then onto a server's NIC as a test - the server could ping VLAN interface IPs that I temporar...
Hi,However, surely I have gone over the platform limit - if I had 245 standard VLANs, and have now created 100 new VLANs from 3000 - 3100 - I should have received an error but the configuration was accepted. show vtp status still has 245 as the curre...
I didn't need 'allow local LAN access' ticked in the client.The problem was that although split tunnelling was enabled, the ACL added by the wizard was for destination 0.0.0.0. I changed this to the network behind the ASA and the client stopped recei...
Thanks - that was the problem. Turns out that the ASDM wizard was adding an exemption rule, but for some reason it was adding it as management -> inside, instead of inside -> outside.I have noticed one other thing though - the default route on the cl...
