Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
This happens when entering the command: software install file usbflash0:cat3k_caa-universalk9.16.03.03.SPA.bin new force on-reboot
Boot variable screen shot is attached
Directory of flash: is attached
Thanks to all those that have inched me along my CISCO® path in my new job as network administrator. I still have a long way to go as shown by my first foray into sub-interfaces. We have a need to route through two different paths from core to anothe...
Your question is old but I had quite a time finding the location to delete an AP from Prime 3.0 also. Click on the 3 line menu bar in the top left corner. Then hover over inventory and select Network Devices under the Device Management heading. Using...
Issue appears to be that the booted path is : version3.0.7 instead of the packages.conf even though the boot variable was set to flash: is still looks at the pervious booted path.
I found a copy on flash-2: and copied it back to flash:
Everything w...
Hi everyone,
I just found a different way to get the information.
This assumes that you have IP tracking on and a switch that supports it. The 3850 does!
Enter: show ip device tracking interface g1/0/4
Result:
-----------------------------------...
Hi,
I know your answer is 3 years old but I think your information would be a great asset to me as I am just starting out with Cisco devices in a very large environment. The URL you reference no longer exists. If your'e still around could you repost...
