Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an ASR1001 installed and I want to implement the firewall feature set.The current license level is IPbase and I have the firewall feature installed. The firewall feature shows acive, Not in use. I have tried to activate it without success. My...
I have the typical Guest wireless setup with 2 4402 anchor controllers in a DMZ connected to an ASA55220 with 3 WLCs on the inside network, one 5508 and 2 4404s. The inside WLCs are running the same code - 6.0.188.0 and the anchor contollers are run...
I am looking at deploying the 4948E switch in my enviroment to replace a 6504 with Sup720 10gig blades. The 6504 is using the XENPAK-10GB-LX4 to connect to my core and the core is using the same Xenpak. I don't want to replace the Xenpaks in my core ...
I have a C6504 with dual sup32-pisa's. I need to upgrade the IOS on the sups and want to do the upgrade without any down time. In a test environment I have tried to do the upgrade according to the documentation but I loose connectivity to the switch ...
I am implementing an MPLS network on 2800 platforms. I am having issues with the configuration. I am trying to enter the 'ip cef distributed' command and it won't take the distributed sub-command. Also when I try to enter the 'tag-switching ip' comma...
It was an IOS issue. We needed the K9 version of the IOS to activate the licenses. Once we upgraded we could activate the firewall license.SteveSteve SjobergSr. Network EngineerTerra Nova Group, Inc.cell - (206) 915-3002
Jon,Thanks for the link. I checked it out but it is still unclear whether you can activate the firewall feature set with IPbase or you need to install the PAK for advanced IP services to activate it. I have IPbase installed currently along with the ...
Surendra,I figured out my issue with the 4404s. It had to do with mobility anchors associated with the guest WLAN. The controllers were connected but not the WLAN. When I activated the mobility anchors on the foreign WLC it started working. Thanks v...
Since upgrading the IOS didn't work I moved DHCP to an external L3 router and I am still having the same behavior where the 5508 works and the 4404s don't. So I it looks like it is an issue with the foreign WLC and not the Anchor.The SSID for WLAN is...
The DHCP scope is configured on the Anchor WLCs I looked into moving DHCP to a server or another L3 device but it wasn't going to be easy. Instead I went another route and upgraded the Ancher WLCs to 6.0.202.0. but I got the same results, the 5508 wo...
