Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hellow happy people, Did any one enabled automatic backup of ASA configuration using EEM. I am going to try it out. What will be the challenge which i can forsee before i go ahead? Something like high cpu/mem utilization etc.. event manager applet ...
Dear all,
I have a very simple question. Basically information converted in to stream of bits (1's and 0's) and transmit, in the receiving end Both Link layer and Transmission Layer runs error checking. Any one please elaborate why is these two c...
Hi , We have a site-site and remote vpn configured in same interface in ASA 5520 ( software version 8.3 ). When Remote vpn users try to connect to computers located on the distant end of site-site VPN, their request failed. I tried No-Nat between ...
Hi Cisco Family, Hope you all are donig good.Can any one please help me to NAT traffic to internet based on XFF value (IP address) in IP header in ASA 5520. IF not possible in ASA, can this be done in any cisco Routers? how?.Thanks and RegardsS...
Hello Mohammed, Here i have a quick query. As per APNIC doc (Page27) below , the third and fourth packet in ike Phase 1 is DH exchange, and 5th and 6 th is Peer Identity. Is this information true. You said preshared key mismach which comes at peer id...
Let us assume Inside is having x. series IP and Wireless interface is having y. series IP. You can enable web VPN in inside interface of ASA and after conneting the laptop to wireless network, connect anyconnect using the inside interface IP.-Shankar
Ohh thatz great thank you..We had planned that option too..but to pull the config from ASA by using tool requires the credentials to be cached or saved in the tool, which can not be accepted by our security policy.. So the EEM solution..
