Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Just an informational post to maybe save some one some time.
We recently updated from 3.1(1e) to 3.2(3a). In the process of doing so our pVlan's quit forwarding ARP broadcast traffic to vMware guests. After much trouble shooting and insistence...
Hi,since we implemented port security a couple of years ago we have seen some odd behaivor on a few occasions, where a port will go err-disable for psecure-violation. when we go look at the source mac that caused the issue there is some garbage mac a...
Hi,trying to TS a VPN device that is behind an ASAbasic set up is IOS VPN<firewall/nat<internet>ASA/nat>IOS VPNI do not have a lot of insight into the other side of the connection, although the tech on the other side claims all is good.so to the poin...
i get these messages from our edge wae device, they have various host ip's not sure what to make of it. there is no routing loop unless waas/wae is doing something that i am not aware of to cause that to happen. wae is in a seperate net from the user...
hi,i am having some trouble with a wae 502 running as a print server we are running latest software 4.0.17. after configuring print services and pushing drivers out via central repository and disconnecting all admin users from the wae the net use \\w...
Apologies for late reply, was OOO for a few days..Looks as though you have the PCI/vmnic association sorted. I just had to do some stare and compare work to make the associations between what the CLI and vcenter shows.Screen shot attached to show wha...
Forgot to mention I also built a vNIC/vHBA placement policy for the service profile. This was done to be sure our vHBA's were always at the top for boot to SAN. Everything else is spread as equally as possible across the four vCon's.
Yep its a mess to get sorted and there are likely better ways to get it done...Working from memory here.I built a new service profile in UCS manager with the additional NIC's.Pick a host and remove from the cluster in VC.Remove the existing profile f...
This caught me out too and this is not a great answer but..The solution I came up with involves manually reconfiguring the vmware vmnic to the PCI address I wanted it on and then building host profiles in virtual center to enforce this configuration ...
Petenixon,thanks for your reply.I understand the reason the switch is shutting the port, what I do not understand is why it is seeing this second bogus mac address on a port that has not changed state.
