Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,
I have had several Service Request at TAC where the customers with ISR4300 or ISR4400 are unable to copy the IOS-XE code over TFTP and they will be receiving a time out for the connection.
After 3 hours trying with different termina...
Hello everyone,
I have had several Service Request at TAC where the customers with ISR4300 or ISR4400 are unable to copy the IOS-XE code over TFTP and they will be receiving a time out for the connection.
After 3 hours trying with different termina...
At 9.2.8 NLB in Multicast and IGMP modes are supported on the N9K switches.
I tested the commands on a 9336C-FX2 and they were accepted.
Please check the link listed below:
https://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus9000/sw/92...
I have a customer who configured a port-channel connecting a Core VDC to an OTV VDC, the port-channel will flap at both ends mentioning that the partner is delayed with the LACP PDU.
For the peer-link I have found that it is not recommended using L...
Hi regarding this question, you may configure the service 61 out and 62 in on the WAN interface, but need to remember to configure the ip wccp redirect exclude in on the interface where the WAAS appliance is connected to in order to avoid a possible ...
I have found that every single service you want to configure are UDP services. As far as I can see on the Silverpeak configuration guide it may use UDP or TCP ports. The WCCP configuration must match the services on both devices, the WCCP Router and ...
