Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, looking for some guidance on a strange issue. We have a standard CUCM setup with a T1 line out to our telco provider, which is setup for North American calling only. We have an assigned toll free number from the telco, however when we make out...
Hello, I am looking at deploying a cisco ISR router at another site, connected to a T1 line with a toll free number associated. Is it possible to use an existing PUB/SUB/IMP/UNITY environment to manage and route calls for this? Diagram below is what ...
Hello, we have LDAP setup and syncing successfully in our CUCM environment. When I try to login to cisco jabber client I am getting the error that the username or password is not correct, I have already verified the following:
username and password
L...
Hello, we have two voice routers with the same config, one router shows the proper trunk port in use and the other shows the following: (Note at the bottom it says Current trunk none selected)...trying to understand why.......
show trunk groupTrunk g...
Hello, trying to figure out how to have one user control two softphone devices that are located at different sites. Current config is:Site A:Publisher, IM& P primary, Sub and Unity serversDevice DN #1 on Media grp, device pool, CSS and Partition conf...
Circling back around on this question. I have configured the Site B router in my diagram above in a separate partition, media group, route group, line group, etc and the router is showing it's SIP trunk is connected. However, when attempting to test ...
