Hello, Question regarding WLAN only sites. If an AP (4800 series) goes down, is it possible that the clients connected to that AP could fail over to another AP and impact network performance for all the clients connected to that single AP?  

Could the command below impact a device's ability to negotiating at 1000/full? srr-queue bandwidth command share 1 30 35 30 

Hi, Going from Access to Distribution layer Cisco's recommendation is a 20:1 subscription ratio. Is it possible to dynamically throttle switch ports (prevent devices from connecting at 1000M) once that uplink threshold is met?  Regards,-Alex

Hello, I've got a 9300 switch connected to a 2921 router. I noticed that the gig up-link on the router is hard coded to 100Mbps.Is there a reason this interface would be throttled?Thank you!

Hi, If I store a copy of the startup config in flash could the flash chip be removed and installed in another 3850 in the event of a device failure?