Hi all, I have a strange problem:I have a 3560 with 8 VLANs configured. Each VLAN has a Layer 3 (IP) interface configured. On 4 of the 24-ports in the switch I have them configured to support a voice and data vlan (dot1q trunked) as I have Mitel 5...
Hi All,I've found loads of docs that say Cisco CNS Network Registrar 6.1 is supported on Windows 2000, is it assumed then that its supported on Windows 2003 ?RegardsNathan
I have PIX 515 v6.3 configured to allow VPN Clients to connect using the Unified VPN Client 3.x.The VPN clients have been successfully establishing VPN Connection to the PIX for a while but beyond VPN Group Name and Password, the client isn't asked f...
Could someone please clarify for me the throughput capabilities of the WIC-1T Interface..I understand that the maximum speed supported is 2Mbit/s....does this mean in any one second, the interface can received AND transmit 2Mbit of data? If data arr...
Could someone please clarify for me the throughput capabilities of the WIC-1T Interface..I understand that the maximum speed supported is 2Mbit/s....does this mean in any one second, the interface can received AND transmit 2Mbit of data? If data arr...
I have been doing some more testing and I have now discovered that large packet transmission was something to do with dot1q tagging of the native vlan. I thought this was disabled but wasn'..I used the command "no vlan dot1q tag native" and this has...
Thanks for the information. .Could you provide an insight for this problem.....During testing I simultaneously started two large FTP transfers (300Mb File), one from siteA to siteB and the other from siteB to SiteA across a 2mbit/s Frame Relay PVC. ...
I have heard that the ZoneLabs Intetgrity Server can provide a good solution for FW/AV & Patch Management on clients, do you have any experience with this product ?
It depends on how you have deployed your VPN Remote Access users..By default, if you enable IPSec-Over-TCP or IPSec-over-UDP, then port 10000 is used for both, these methods are Cisco Proprietary and can be changed..If you use NAT-T (NAT Traversal), ...
I've just recently set up this exact scenario at a customer site and it works fine..You must make sure that the IPSEC protocols are allowed through the firewall to the NAT address you have used for your VPN 3005 (typically ESP and UDP/500 for ISAKMP)...
