Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Old neglected DEV environment. Not on support, so no TAC case possible.UCS Central 2.0(1r)UCS Manager 4.2(3i) on 6248UP pairI found how to recreate the certs in CLI for Central and Manager and did that.I found how to set the shared secret in CLI for...
I would like to establish a VPN connection from a Windows Server 2012R2 VM in our main corporate environment to the environment of one of our subsidiary/partner companies. This works from my Win10 laptop just fine, but the install won't run on Serve...
I'm setting up a pair of UCS 6248 FIs in a DEV domain. One 5108-AC2 chassis is attached via two I/O modules. There are four B200-M4 blades in the chassis that I want to install ESXi 7.0.2 on (using SD cards for boot devices).PROBLEM: I can't get a...
Hi. I have tried to decommission and then recommission an empty 5108 AC2 Chassis. Well, empty of blades. Fully populated fans, power, and IO modules. Upon recommission, I get an "Accessibility Problem" messages as the status. There are very few se...
Why do UCS system event logs show 1970 dates? This SEL was cleared a couple days ago. I see this A LOT in UCS. What's the deal? Number of SELs:81 | 01/12/1970 23:46:43 UTC | CIMC | Event Logging Disabled SEL_FULLNESS #0x9b | Log Area Reset/Cleared ...
@amojarra We are also moving to AHV. Would like to see this officially supported by Cisco asap.@Chloeharper Can you share specifically what networking changes you made to get it to work in AHV? I'm familiar with the ESX requirements.
Steven got my inband/outband issues cleared up, and as a bonus helped with ESXi management network issue I had (ESXi was grabbing vNIC0, vNIC1 and labeling them as 2 and 3, and vice versa). Thanks Steven!!!
Steven,Message sent. I'm sure I'm missing something basic or fundamental in trying to set up this environment. I've been able to build an ESXi host, but I can't get it to communicate on the network either.
Oh, and the Physical IPv4 Outband KVM connection on a different vLAN/network works fine. It's only the Service Profile provided IP that times out. Thanks.
