Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We have started facing this issue recently where our Public IP Address with AT&T cannot be accessed by anyone especially for people using Comcast Internet. We have two core routers with iBGP configured, please refer below topology: So the iss...
Hi,
Cisco 2911 - LDAP Locks up after an login using incorrect password over VPN, we have to clear LDAP server using the below command for any user to connect again.
clear ldap server DC01 (DC01 is the ldap server configured)
Below is the debug when ...
Hi There,
I am having an issue with setting up PBR to make use of secondary ISP which is sitting idle. Here is our network topology!
Gi0/2 - 10.10.10.1/24 LAN Subnet
Gi0/0/0 - 200.200.200.1/30 ISP1
Gi0/0 - 100.100.100.1/30 ISP2
Default routes:
i...
Hi Guys,
So here is what happened, our Site to Site connection between Cisco 2911 and ASA 5510(Initiator) went down! Upon doing packet captures from both end we found that the router is not receiving any IPSEC(UDP 500) packet from ASA. However ASA w...
Hi All.We have a couple of Cisco IP Phone 7965G which is restarting in a pattern at certain interval of time.Firmware version is 9.3(1)SR1.IP Phone 7965G with Firmware SCCP45.9-0-3S are not rebooting.We are unable to downgrade the 9.3 phone to 9.0 be...
Thank you for Replying, Rick. Actually that is the part that I am having trouble with understanding. We know the packets are being pushed to router 2 but not sure why they are not reaching to an end user. Thanks,Rijath Mohammed
Hi Rusty,
Could you mind explaining how you have configured the below? I know it is definitely not using terminal -
Created business VPN NPS network policy.
Under the Constraints tab I added the Authentication Method constraint specifying "Microsof...
Hi Philip,
Found a workaround for this issue:
LDAP requests are successfully authenticated until any one of the user connects with an incorrect passwordFrom that moment, 'User is rejected' message will be send by router even when a user tries with c...
