Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybody !!I need to know whta ethernet switching method does Cisco 4500 switches use;Store and Forward, Cut-Through o Fragment-Free.Does this methods are configurable ?Best Regards !ELO
Hi Everyone !I have a doubt about upgrading Memory in Redundant Supervisor Modules Nexus 7K18, i read the Cisco Nexus 7000 Series Hardware Installation and Reference Guide, and the process for upgrading the memory in redundant supervisors do not says...
Hi everybody ! i just deployed Cisco NAC version 4.8.1 Virtual Gateway OOB on a LAN envieronment and on a WLAN envieronment, it works fine for some users , they can authenticate via the agent or web page, and then they are redirected to the access vl...
Hi Guys, im just deploying CUCIMOC on a customer, but i have some laptops with rcc enabled in the MOC and wjen i install the CUCIMOC plug in it does not works, can anyone help me, in how can i disable rcc (moc voice), in the MOC Panel in order to get...
Hi !!!!I have the following problem with the plugin CUCIMOC 7.1.4, if i enable it in a laptop without Nortel IP Telephony App enabled , the CUCIMOC just work fine, but if i try to enable it with Nortel IP Telephony App enabled laptop, i just doesnt c...
Hi im still in test with this issue, i put an sniffer on CAS ports and CAMports, and we can see that SNMP packets are being dropped in some point ofthe trace, the point that we are reviewing at this moment is the WAN linkbecause the CAM & CAS/Control...
Hi , i just reviewed the snmp configuration on all the switches and WLAN and CAM and is fine, and is working because some users can authenticate , but some others cannot in both envieronments and if the snmp parameters where the cause, none of the us...
Hi Jon & Rtjensen4I just configured my route maps as you suggested to me and the seggregationof the traffic its working fine ! Thak you for the help !Best Regards !ELO|
Hi Jon thanks for the answer, i just tried what you recommended to me, but it still dont work ..... i put the set statement for each of the Route maps, and i applied the route maps to the dialer just as you suggested me but stil doesnt work , does i ...
