Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My provider is telling me that I can take my frame relay network and map it into their MPLS network. Basically all my sites would connect into the providers Frame network and then mapped into the proivders MPLS network. Now I know this will work; b...
Let me clear this up. I have 2 internet connections that I need to load balance across as well as use for failover. What I need to do is have my Internet routers advertise via OSPF default route, but I need DMZ1 (PIX1) to be routed out Router1 and ...
Let's see if I can explain this. I have 2 ISP connections, one is an OC3 and the other an OC12, they are on 2 different routers each feeding to 2 different DMZ's. What my question is, because of billing (the OC12 is burstable whereas the OC3 is a f...
We just purchased a company that is using Symantec Enterprise Firewall v7.0. And we are going to replace it with a PIX 515, however there is a catch. The Symantec supports ~20+ dynamic IPSEC VPN users, using the Symantec VPN client. My question is...
I has been a long time since I have worked with a PIX device, but when I remove a NAT static statement, do I have to reloasd the PIX to get that removal to take? PIX525, v 6.2
Like it is already stated ther might be some specific features that the CatOS andios combind might bring on, but it is easier to maintain on 1 IOS as opposed two.Here is the doc I always use:http://www.cisco.com/en/US/customer/products/hw/switches/ps...
I understand that. My question was a layer 3 question, not a port question regarding the MSFC. When the MSFC get a packet in from subnet A (doesn't matter what the physical port is), and needs to send it to a host on on subnet B which is one of the...
'The switch will only forward packets inside the vlan they are received on'What about the 6K receiving a packet on the MSFC and needs to forward to a host on the switch? It will do an ARP lookup to resolved the MAC address then a MAC table lookup to...
