I'm trying the acheive the following using our ACE modules in the Catalyst 6509when some tries http://intranet --> it should get redirected to https://intranet/abc/wps/portalhowever when someone tries https://intranet/pkmslogin.form it should go to t...
I wanted to export the entries in my IP phone's personal address book to CSV. would this be possible? and how?We are using CUCM 6.1 and 7941G IP Phone.Will appreciate any support/inputs
We have an ASA 5540 failover bundle working in Active/Standby mode. On our active asa 5540 when the sh run command is issued it gets stuck and displays the output after more than 15-20 mins.. and it takes another 10-15 mins to get back to the prompt....
We have an ASA 5540 failover bundle working in Active/Standby mode. On our active asa 5540 when the sh run command is issued it gets stuck and displays the output after more than 15-20 mins.. and it takes another 10-15 mins to get back to the prompt....
We have CUCM-BE 7.x working & we want to have the mobile communicator enabled, so can I use the same CUCM-BE hardware & only purchase the mobility advantage server software & mobile communicator client software...
Hi Titto,In order to lower the snmp syslog trap level to warning, issue the below command.logging history warningsYou may also look at the below commands too, if you are also hitting with the same issue of CPU utilization.logging trap informational ...
Hi Karuppu,Yes we are using SNMP tool for monitoring, we have Ciscoworks LMS, Cisco Security manager, Cisco MARS.. But this has been working all these days, the problem started only from yesterday...Now after I have lowered the the snmp syslog trap l...
Right now it is the same behaviour in standby asa too, and this was an working setup, it was working fine all these days and this problem started only since yesterday...the cpu utilization is 95% in both the asa and I see the cpu utilization of snmp ...
Sushil, thanks for the clarification...But still one more doubt, do I need this "Nokia Intellisync PBX Connect for CCM (SCCP Client)" too? if not in what case would this be used??Regards
Hi Sushil,Thanks for the reply...We actually wanted to integrate the blackberry & nokia phones to our CUCM, so is the mobile communicator a right choice? or is there something better??Regards