Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to establish a vpn from Windows 7 without any other client to a Cisco 1801.Is L2TP the best way?Where can I find some information for configuring it?
I have a T1 that is handed off with ethernet. I need to do QOS on the line for bandwidth sharing of two servers. Ihave configured the fa0/0 with a few policies but they all seem to be using the 100mpbs to base the QOS on. I have set the bandwidth com...
I have a cisco 871 128MB Ram It is running our main DSL line with about 500 computers behind it.... what would the max sessions you think one of these could handle I was looking in show ip nat translations and found about 1600 current translations
I am setting up a router that has a T1 and a DSL linkI have configured the interfaces and put the outside and inside for the correct interfaces but I can only get nat working on the T1. I feel as if maybe the router is using to T1 line IP address whe...
Hello, I have a 1841 that I am looking to setup Dual WAN Dual NAT. I know that you are not supposed to have the DMZ on a VLAN but did not have a choice at this point. Here is my question I have one T1 and one DSL line that I need to be able to use. T...
I would agree..What do you think would be able to manage this amount of connections? do you think a 1841 could do the job?The 871 is lagging after a long day of keeping up with the nat translations. causing extreme latency up to 1sec when it is usua...
Keep the ip the same on the 1841 and just map the 69.x.x.x external ip address to the internal servers or dont if you have nothing access from outside.
