Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All, Sort of a fringe question, but I discovered that my primary trunk port 0/47 on my lab's core switch (to the router) is going bad. Long story short, I'd like to permanently disable the port physically so that I never accidentally plug anyth...
Hello all, I recently did a cheap(ish) upgrade to my home lab because I hadn't done anything for a while and my 2600 APs were getting a little dated. I bought a batch of 2702i's off ebay to lab with. The first AP I plugged in worked fine (with a date...
Alright guys, I've been scratching my head about this one for a few weeks and I'm hoping I'm just making a simple PBR mistake and someone can help me out. As you can see (hopefully) all the traffic from my home network goes through my ASA. That's al...
Hello all, I have a small home network running a ASA5550 as my boundary gateway, but it's been jamming up my wireless network. The topology is as follows: |Cisco WLAN Controller| ---- |Cisco ISR| ---- |Cisco ASA5550| ---- |Internet| Since installing ...
Hey All,I'm running an ASA 5550 out of my home network and, overall, things are pretty good. It acts as my gateway (ISP Gateway is in full passthrough mode, all frames get sent to the ASA), and does it's job well.I recently installed a 5508 WLC with ...
When I read the TTY.Console output it just says "Radio 1 Unavailable" for both and the entire confreg is 0'd out so... yeah just wanted to make sure I wasn't missing anything obvious and there were no remedies before I go harass the reseller. Thanks ...
Paul,I guess it had never actually occurred to me to use a "deny" statement in a PBR entry--I've literally never done it and even forgot it was an option. None of my googling lead me to believe a PBR deny would force regular route-logic. I guess I sl...
I can post the full running config in a few hours. The wireless is not a separate zone, there are only 2 zones in the network, inside and outside. All inside traffic has the same trust level and is allowed to travel anywhere. All subnets are in the s...
A 5508 is slightly cheaper and rack-mountable. Would that also work? Which would you choose? It's comparable in price to the 2504, and I honestly don't know enough about them to make an informed decision...
I guess I misread the compatibility numbers and figured 7.x would work cross-platform. Again, zero background in wireless. As someone who has some background in wireless, would you upgrade the WLC to run with the 2602 (I chose that model because they...
