Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,We currently have one Cisco ASA 5516 firewall which we will be replacing with 2 Cisco Secure 1230 firewalls. The 2 new firewalls will have an outside interface, inside inferface and a DMZ. The 2 Cisco Secure 1230 firewalls will work in...
Hello all,We are trying to replace 2 catalyst 3750 switches which are currently stacked with 2 new catalyst 9300 switches which will also be stacked. We just realized that some commands and services are different on the new 9300 switches.I have attac...
Can someone please confirm if these devices are impacted by log4j2 vulnerability: Catalyst 2900 series switchesCatalyst 3500 series switches I don't see them listed under impacted Cisco products but i just want to confirm. Any assistance will be muc...
Hi Guys, Firewall inside interface 192.168.2.1 Switch 1Has VLAN 1, IP Address 192.168.2.5 (Device default gateway) Switch 2 VLAN 1, IP Address 192.168.2.5VLAN 200, IP Address 172.17.0.1 I am trying to create a trunk on both switches to carry those 2 ...
Hi Yusuf,Does that mean configuring the VLANS on both switches with no IP Address and no trunking? I would greatly appreciate your confirmation.Thanks,Lake
Hi KB,Thanks for your quick response.What do you think about this suggestion "no inter-VLAN routing on the Catalyst switches: All traffic between these security zones must pass through the firewalls?" Configuring the two Cisco Catalyst 1200 switches ...
Hi Guys,Please see new attachment with a Catalyst 2960 edge switch configuration which is currently live. in our network. Our new Catalyst QoS will have to match this 2960 QoS config. Would the auto qos command work or do I need to redo the whole QoS...