Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I had a really old DNA sitting on a shelf since before COVID that i just plugged in.I got the CIMC setup and i ran the Maglev Wizard and i do believe it completed (finished after work hours).If i log into the CIMC and Launch the KVM is get a "Welcome...
In this stack summary, what does the "Link Active" mean? I have sites that say "yes" and others that have nothing. I've noticed that if it has "yes" then it is always the "Master" switch that says it. And what does it mean if all of them say "No" ...
We have a Cisco ASR 1002 router and a stack of Cisco 3850 switches that then feed 90+ buildings. every bldg operates on a separate VLAN.We have one 1gig circuit feeding the router. we want to regulate how much bandwidth a vlan can use.what would be...
I can't get past the setup for the configuration until a proper NTP address is entered into the wizard. In my setup the management CIMC address is on our production network but the maglev wizard will be setup to scan and monitor a SEPARATE and un-li...
i have several 2960X model switches that have lost their IOS on the onboard flash during an IOS upgrade.
i want to use a USB to load or copy the IOS onto the onboard flash but the units that are in Rommon will not recognize the usbflash.
i can see an...
No ACL's on the switches......Only changes to this building......Our site consistes of 100+ switches in 70 buildings...only changed this buildingNo cisco port mac binding used...we use ForeScout for port securityForeScout scans every building and pe...
We push IOS images out to about 2000 Cisco routers here. For some reason this one is being temper-mental. The IOS has a vulnerability so it needed to be upgraded. I already squeezed the flash also so I can't "undelete" it. I am curious whether th...
