Hello,
I'm trying to configure WCCP redirection using L2 forwarding on a 3750 Stack but the "ip wccp web-cache" command is not accepted.
Can you please help?
Stack_3750X(config)#ip wccp
^
% Invalid input detected at '^' marke...
Because you also must set up the baud rate on TeraTerm:
This MUST also match on the terminal program setting as well. So (I’m using TeraTerm) under Setup -> Serial Port, set the baud rate to match whatever you set it as in ROMMON
Ok, I finally found the solution. I did the following commands, saved and rebooted:
Stack_3750X#license right-to-use activate ipservices switch 1 acceptEULA
Stack_3750X#license right-to-use activate ipservices switch 2 acceptEULA
Stack_3750X#licens...
Hi,
I did not install the licenses myself (I took the switches as they were, it's for lab purposes) and preferably I'd prefer permanent licenses than evaluation.
Under the file system (flash:x...) I cannot located any .xml licence file.
Example:
St...
I did the following commands, saved and rebooted but it did not solve:
Stack_3750X(config)#license boot level ipservices switch 1
Stack_3750X(config)#license boot level ipservices switch 2
Stack_3750X(config)#license boot level ipservices switch 3
...
Thank you Mark, I've seen that, but I also need to unstack the switches to enable ipservices feature, otherwise the license state remains to "Not in Use, EULA not accepted" status, the "license boot level ipservices" has no effect.