Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have deployed Umbrella SIG solution for our branch users and using AD user based Web Policies and DNS Security policies for web traffic. Can we use the AD user credentials to login to Umbrella Dashboard.
I am installing EPNM 5.0 in VMWare environment following the steps from config guide(Evaluation License). After successful installation I could able to login to GUI with admin credentials but not able to login to CLI. Verified that the Administrator ...
I am facing a problem in ESA regarding Whitelist/Blacklist. I am adding senders email addresses/IP addresses in incoming email policy. But SPAM filters takes action based on envelope sender only(Other Email Security solutions works based on "from hea...
In our existing virtual SMA appliance is in Internal zone and ESA appliances are in DMZ. We are now deploying a new SMA appliance as a replacing for our existing virtual SMA device.We are enabling secured centralised SPAM Quarantine access to employe...
We are deploying 2 Ironport C600V appliance security appliance in our environment with SMA. Two virtual data interfaces configured in Data1 port and we are expecting outbound email from Exchange server will be received in Inside interface then scan p...
In your case PBR must be applied in LAN interface for LAN Server A to force route traffic to Nexthop A for outbound internet access, In this scenario if a fresh inbound connection received at FPR through WAN interface the traffic will be forwarded LA...
Hi, Thanks for your reply. CISCO offers Quarantine email release service in both http and secure http ports. In that case this appliance will also be accessed by users from internet. In that case I have to expose my internal segment to internet users...
@CMR Hi, As suggested by TAC upgraded the firmware to 15.7 Beta and Meraki product team enabled the feature in my console. Now I can enable source NAT at my local interface. Refer the attachments.Due to the problematic device non availability we coul...
