Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day to all, In a small backbon network , we are using the C9200-24T-E .The switches will be used in L3 mode (command IP ROUTING enabled) . So to interconnectd multiple branch sites through an ISP switched Network, we plan to setup site to site...
Hello all ,Lets suppose that we have directly connected routes ,We want to redistribute them into the ospf process except for just one subnet.How can we accomplish this ,I think that we can not use route filtering cuz they handle type 3 LSAs ,Here we...
I am moving from router on stick to an integrated switch module topologie , whats the best way to do it , where to put the gateways ?if i deciede to use svi interfaces inside the switch module , how can we insure the routing between the switch module...
Hello , why i dont see all the interfaces when usinf # sh int status ,like for example the TenG interfaces and the sfp slots ,here is the output of # sh int summaryGigabitEthernet1/0/20 0 0 0 0 0 0 0 0 0GigabitEthernet1/0/21 0 0 0 0 0 0 0 0 0GigabitE...
Can a router be a KEYS and GM at the same time , i need the traffic to be encrypted between the keys and the GMs
how can i do that ?
if there are any resources that will make it easy for me to understand that plz share with me cuz i am having s...
Hello @robertmprsoman Can you share the output of the command # show spanning-tree vlan 10you will see if the channels are acctuely in the FWD status .
Hello , Lets assume that the module in question is a laye two only , witch is SM-X-16G4M2X .after digging a little bit in the module reference i can not know for sur whats the internal port that will be attached to the switch module . the questio...
Hello @Joseph W. Doherty thanks for your detailed post , from what you said i have understood that , if i mount the sm-x module there will not be a routing issue between the router and the etherswitch module that i added since the routing table will...
