Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Currently have a 3825 Voice Bundled router, combined with two UC520 in two remote sites.Right now we have successfully configured for dialing between these three sites. But it seems we cannot make conference between user in HQ (3825) with user in oth...
Dear friends, I need help or guide about how to setup as state in the title. Is this configuration can be done? or the self-signed certificate can never be used for VPN certificate.Unfortunately we can't deploy a dedicated CA Server. But we can't use...
Dear friends, Currently we have just 8 unit of these Aironet access points but it seems our customer didn't have any LWAPP wireless controller devices.So after searching cisco.com i found out that we can downgrade the IOS to older version. I'm using ...
Hello everybody, i need help here, i'm quite new in PIX configuration.Can PIX allow connection from inside to outside to an OracleServer. My costumer just need to buy an firewall to protect oracle server.i have already configured the PIX (without NAT...
guys.i have a couple servers that need redundant connection to our server farm switches (two Cat3550-12T), on the server we have 2 NIC (1000baseT from broadcom)we're running link aggregation 802.3ad but when i try to connect the second NIC to the sec...
Thank you very much, It resolved my issues, after first i downgrade the IOS version to 12.4(20)T the CME version go straight up to 7.0.then i can successfully put all the conference command.Sab
Hi, i'm sorry to get this long to reply.here is the output, show diag , show voice dsp and shot telephony-serviceThank you very much for all input please check the attached file.Sab
Can i use the manual request (http://certserver/certsrv)? or i have to use SCEP method (http://certserver/certsrv/mscep/mscep.dll) ?I'm planning to roll out the certificate into the client's installation CD. So we don't need to re-request certificate...
Hi Gilbert, That's okay i understand.Currently the authentication issue is fixed now.I configured the ASA and CA server using NTP.I think the cisco guide shouldn't put OPTIONAL on the ASA_Cert.pdf guide.I found that NTP is mandatory for these configu...
Hi Gilbert, I've configured a new 2003 Server, and the CA Server. and also install the SCEP Add-on on this server.But the ASA seems failed to authenticate the CA eventough i 've following all the instructions here http://www.cisco.com/en/US/products/...
