Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all- looking for a solution to the following problem.we have a main data center and 300 remote sites connected via the ISPs MPLS cloud. I need to police certain type of traffic from data center (AV update downloads) to each field office down t...
Hi All- I'm trying to figure our the best way to transition a stp blocked port to forwarding while doing the opposite for a forwading port and set that to block.Here's the setup. From an access switch there is a 10gig uplink which is stp forwarding f...
Hello all- we're running ACS 4.x. currently we have "check dial-in permission" enabled. We have VPN users and wireless (.1x) authenticating against acs and then to AD. the problem is with the "dial-in permission check" we have to grant this all vpn ...
aside from doing in-line taps, i'm curious to see what people are doing to get around 2 session limit. I have need to monitor multiple source vlans and it's over-subscribing the destination port. also using vlan and physical interfaces as a source in...
Hi All- I'm trying to figure out which setup would provide more even load balancing across multiple links. Let's say i have a core and distribution switch connecting via multiple links and run OSPF between them. Would it be better to create an Etherc...
thanks for the reply. Could i initiate a topology change by plugging a host or something? i do not want to kill traffic by shuting down the link..any way to avoid doing that or am i going to lose traffic anyways during the topology change?
thanks..This will be between juniper and cisco..potential for some link aggregation incompatibilties..also juniper doesn't let you configure which algorigthen to use for load balacing on an aggregated link. L3 links might be a better choice here to a...
