Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I tried to made first configuration for the router using CCP Express Wizard.After information that the router will be restarted nothing is written to the configuration and in the flash new file has shown : crashinfo.Any suggestions ?? This is fragmen...
Unfortunately one of my 871 have a problem with configuration.I can get to him only by AUX.It runs only with default configuration. When I want to copy my config to startup i received information: NV: InvalidPointer value(1884) in privateconfigurati...
I have few networks which are connected together through VPN tunnels.All static routes to networks 192.168.3.0 and 192.68.9.0 are configured on router 4.From the network 179 I can ping everything but from the network 3 and 9 I can only ping 179. Wher...
I'm using IP SLA to switch internet to backup connection when the main ISP goes down. Unfortunately the SLA removes route map every 60 seconds and add this route even if the main ISP is not working.In this case I have internet for 60 sec. trough back...
I want to create VPN connection between routers. One of them have static connection. Another one have only GSM connection with dynamic IP address.Can I use DMVPNfor that case?? How to configure it.
This the config of the R3Building configuration...Current configuration : 6100 bytes!version 12.4no service padservice tcp-keepalives-inservice tcp-keepalives-outservice timestamps debug datetime msec localtime show-timezoneservice timestamps log dat...
There is communication only between 179 and 3, and 179 and with 9.There are no communication between 3 and 9 through 179. The routing and the gateway for R0 and R2 are configured on R4: ip route 192.168.3.0 255.255.255.0 192.168.179.12 ip route 192.1...
