Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to change the AD of some EBGP routes so that OSPF is the preferred path.This is what I have configured (it isn't working):ip access-list standard SetDenADpermit 130.77.208.0 0.0.0.255 neighbor 172.20.30.2 soft-reconfiguration inbound neighbor ...
The 5550 is rate at 1.2 Gbps. But that througput is split between the 2 interface busses right? Actual throughput is 600 Mbps for slot 0, and another 600 Mbps for slot 1?
Hello,How does header compression work if the receiving router doesn't have compression configured? I want to test this, but don't want to enable it on our entire WAN, I just want to make sure that I am not going to break traffic between the test si...
I need to add some new VLAN's to our core 6509's. The last time I did this I believe the addition of the (vlan xxx) caused spanning tree to reconverge across all MST instances. Our Spanning Tree configuration is below. Is that the correct behaviour...
When using Wireshark to sniff traffic on the LAN we see OSPF and HSRP advertisements on port terminating client machines. Is there a method for preventing the swich from flooding the keepalives/advertisments out all ports?
can you add the prefix list to your test? I think the prefix list in my test is passing the route, and it never hits the distance command.Thanks for looking at this
This is a test, I didn't want to drastically change routing without seeing it work the way it should. I did clear BGP, it still didn't change the AD of the test route.
Thank you, in that case is there a best way to add multiple VLAN's to minimize the outage? Script the changes and hopefully they all go in 1 convergence?
