I have configured Netflow in the port TE1/0/10 and TE2/0/10, but Netflow are not working.
This is the configuration.
!
flow record Netflow-In
match flow direction
match interface input
match ipv4 destination address
match ipv4 protocol
match ipv4 source address
match ipv4 tos
match transport destination-port
match transport source-port
collect interface output
collect counter bytes long
collect counter packets long
!
!
flow exporter Netflow_SRV
destination 10.1.10.141
source Port-channel1
transport udp 9996
!
flow monitor Netflow-Monitor-In
exporter Netflow_SRV
cache timeout inactive 10
cache timeout active 60
record Netflow-In
!
MG_CORE#sh interfaces port-channel 1 etherchannel
Age of the Port-channel = 15d:02h:58m:05s
Logical slot/port = 12/1 Number of ports = 2
GC = 0x00000000 HotStandBy port = null
Passive port list = Te1/0/10 Te2/0/10
Port state = Port-channel L3-Ag Ag-Inuse
Protocol = -
Port security = Disabled
Ports in the Port-channel:
Index Load Port EC state No of bits
------+------+------+------------------+-----------
0 00 Te1/0/10 On 0
0 00 Te2/0/10 On 0
Time since last port bundled: 12d:23h:04m:54s Te2/0/10
Time since last port Un-bundled: 12d:23h:06m:20s Te1/0/10
!
interface TenGigabitEthernet1/0/10
description *** ENL a ROUTER 7600 puerto G5/1 ***
no switchport
ip flow monitor Netflow-Monitor-In input
no ip address
channel-group 1 mode on
end
!
interface TenGigabitEthernet2/0/10
description *** ENL a ROUTER 7600 puerto G6/1 ***
no switchport
ip flow monitor Netflow-Monitor-In input
no ip address
channel-group 1 mode on
end
MG_CORE#sh flow monitor Netflow-Monitor-In statistics
Cache type: Normal (Platform cache)
Cache size: Unknown
Current entries: 0
Flows added: 0
Flows aged: 0
!
