Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My current environment is 2 4402 controllers with 20 1131's Lwapwlans work fine using WPA2/AES/802.1x/EAP-Fast using Cisco ACS v4. to external db Microsoft AD for creditionals.My question, is it possible to get Ipx working, we have a large group that...
Hello All, I 'm currently implementing voip to my Frame\Atm Network.The specific problem occurs when dialing a Frame remote from the Atm headend router there is a loud beep just before call connectsi'm using virtual templates with mlppp ...
Volven, Starting on the WCS server, Administration/TACACS, i added a server,AAA mode was then set to TACACS.On my ACS server i added the WCS server under network devices and AAA clients, using the same shared tacacs key.Next under Policy ele...
GOT IT, i added another match condtion (NDG) in the Device Administration Authorization Policy, and then for my rule-1 which enabled Priv 15, i addednot in NDG device type WCS, this way everything matched on it except my WCS server, so it used the cu...
I worked with TAC on this yesterday, we were able to get my WLCs working with ACS 5.1 using Radius....NOT Tacacs,this only remaining issue i have is with WCS, trying to match the correct Auth policy, if i match to enable priv 15 , all cisco hardware...
I've got my own dialer watch issues, but i think you need to add the following to your bridialer map ip 172.31.4.192 name R2 broadcast 56280xxx For every watched route you need a matching dialer map for it.
Rob, Actually it is possible, i changed the ap mode from local to Hreap, then on my wlan config i checked Hreap local switching, now the client data stays local on the ipx enabled vlan while the control functions are still tunneled back to the cont...
