Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Support, We have FMC 2500 appliance where fiber card 10 GB is integrated.we are trying to move the management copper port , to the fiber ports 10 GB. however , if you go to system > configuration > management interfaces , you will only see eth0 ...
Dears, i need to generate a CSR from a cisco router.once done, retreive this CSR from the router and give it to a company to sign it.once signed, install the new certificate on the router. kindly , if you can provide me a detailed step-by-step on how...
Dear Support, I have a s3260 server (UCSS-S3260) with a network card (UCSC-PCIE-C25Q-04 = Cisco UCS VIC 1455 Quad Port 10/25G SFP28 CNA PCIE) that is installed on the SIOC (UCS-S3260-PCISIOC) card in the server. This server is connected to a nexus sw...
Dears, we have voice gateway with E1. Can you send us the detailed step by step configuration for the below scenario : Customers (from outside the company) should call 07713454545 (specific E1 Number on voice gateway), so the voice gateway should re...
Dear Support ,
After formatting the whole flash of a 5508 WLC , and even when we tried to upload new image via bootloader , the wlc restarted and the bootloader immage appear again.
is there a way to upload an images so the wlc can start normall...
Hi Marvin, Indeed.this is what i want.the SFPS are Cisco SR-S 10GB. they are blinking green on the FMC and switch side.But my issue that the FMC is not recognizing it. Best Regards,
